January 04, 2015

0 Comments




 

1975: The Duke Contest at Sunset Beach, Barry Kanaiapuni suiting up and  TF with his brand new Sunset Gun. BK 's surfing at Sunset set the bench-mark for generations to follow.

1975: The Duke Contest at Sunset Beach, Barry Kanaiapuni suiting up and
TF with his brand new Sunset Gun. BK 's surfing at Sunset set the bench-mark
for generations to follow.

From the Vault: Rocky Point, November 1971 Jack Reeves (Hawaii's premier glasser) checking TF's repair work. No leggies at Rocky meant repairs and a new fin before shooting a session for 'Morning of the Earth'. Photo Albe Falzon See 'Sultans of Speed' on The Surf Video Network

Rocky Point, November 1971
Jack Reeves (Hawaii's premier glasser) checking TF's repair work.
No leggies at Rocky meant repairs and a new fin before shooting a
session for 'Morning of the Earth'. Photo Albe Falzon
See 'Sultans of Speed' on The Surf Video Network[/caption]


Duke's Day 2015 - Shaping HB Rainbow Boards

A 7'6 Hot Buttered Sunset Gun (Rainbow Board) will be on display at this week's Duke's Day, Freshwater. Jack McCoy asked Terry Fitzgerald to comment on the original board he rode and the following handshapes he created from the 1971 Duke Kahanamoku Classic in Hawaii in which Terry was the finalist and Australia’s only representative. The TF story is as follows (extracted from copy written for Rusty P... and used in TSJ a couple of years ago):

• My very first idea came from Bunker, surfing Pokala rights in summer
1971. He had a rope handled kneeboard which he paddle in laying down,
took off on his knees and then pulled on the handles for his trim line
and then stood up. He had small keel shaped resin fins stuck in the tail
rail to help keep a high line.

• The jump came in the our winter of ‘72. My Hawaiian influenced boards
just did not have enough tail area to skate over the flat-spots at Narrabeen.
So, I ADDED wings (or what we called flyers). The idea was that ß
by adding the wing to the rail it would add more planning area flat, but,
you would still have a narrow tail for in the pocket and bigger waves.
The ‘wing/flyer’ had to be pinched to allow the rail to stay in the wave
and run you higher as well (á la Bunker’s idea). But, the wing also gave
you a break point for snapping out of the lip. So, three pure benefits
i) More planning area to get across the flats
ii Pinched wing to stick in the face and ride high on
iii) A break point in the rail to snap off the lip on
Tested in Hawaii that year and then launched in December ‘72,
January ‘73 in Australia.

• ADDED: note - wings we not something you created by cutting a piece
out of the tail of your board. They were ADDED to the rail line / foil
and planshape...and pinched to have minimum effect of rail line
entry and line, but, maximum effect on planning area when flat,
plus the increased ability to run high and hold a high line.


“My whole wing thing only came with concaves - a double edged development.
Concave to get you up the face, wings to hold the high line.” TF


Leave a comment

Comments will be approved before showing up.